In case your water heater will not be heating water correctly, the heating factor could also be accountable. The heating factor is a comparatively cheap half that’s straightforward to switch, so it’s a good suggestion to attempt changing it earlier than calling a plumber. On this article, we’ll give you step-by-step directions on methods to set up a heating factor in a water heater.
Earlier than you start, you will want to collect the next instruments and supplies:
- New heating factor
- Wrench
- Screwdriver
- Electrical tape
- Flashlight
- Security glasses
Now that you’ve gathered the mandatory instruments and supplies, you might be prepared to start the set up course of. First, flip off the facility to the water heater on the circuit breaker panel. Then, flip off the water provide to the water heater and open a scorching water faucet to alleviate any strain within the tank. Subsequent, drain the water from the water heater by opening the drain valve on the backside of the tank. As soon as the water has drained, you may take away the previous heating factor by unscrewing the nuts that maintain it in place. Make sure to put on security glasses when you’re eradicating the previous heating factor, as there could also be some residual water within the tank that would splash out.
Set up a Heating Aspect in a Water Heater
In case your water heater will not be heating water correctly, the heating factor could also be defective. Changing the heating factor is a comparatively easy job that may be accomplished in just a few hours. Listed below are the steps on methods to set up a heating factor in a water heater:
- Flip off the facility to the water heater on the circuit breaker or fuse field.
- Flip off the water provide to the water heater.
- Drain the water from the water heater by opening the drain valve on the backside of the tank.
- Take away the entry panel to the heating factor. This panel is normally positioned on the high or backside of the water heater.
- Disconnect the wires from the heating factor.
- Unscrew the heating factor from the water heater tank.
- Wrap the threads of the brand new heating factor with Teflon tape.
- Screw the brand new heating factor into the water heater tank.
- Join the wires to the brand new heating factor.
- Exchange the entry panel.
- Activate the water provide to the water heater.
- Activate the facility to the water heater on the circuit breaker or fuse field.
Individuals Additionally Ask
How do I do know if my water heater heating factor is dangerous?
There are just a few indicators that your water heater heating factor could also be dangerous, together with:
- The water will not be heating up correctly.
- The water heater is making an odd noise.
- The water heater is leaking.
- The heating factor is visibly broken.
